If you have the pro 2/3 touch, you have the option to connect peripherals to the printer via USB. The touchscreen is basically a Linux PC, where you can connect several USB peripherals to. These are the things known to work via a USB hub or directly to the USB connection of the touchscreen. ...
Please see this video to see a best practice to apply kapton tape, which can be bought in our webshop.
Tips and tricks:
Use thicker kapton sheets > 0.15mm thick, allowing easier application of the Kapton and also these thickness will last at least a couple of months of intensive ...
The following methods can be used to unclog the hot-endA clogged hot-end can most of the times be cleaned. There are several methods to do so. The six most common methods are explained below. Method 1. Overheated extrusion – No disassembly needed• Heat up the hot-end to 210 ᴼC for PLA or ...
A potential point on the first generation of heated beds (Pro Series ONLY) might cause a defect. This defect only occurs on first generation FELIX Pro series heated beds assembled from October 2015 till May 2016. Due to a possible bad connection between the printer and the print bed, the ...
