The FELIX pro has a ballscrew with very low friction to ensure accurate z-axis movement. This in some cases especially with a heavy object can cause the z-axis to move down by itself at a low speed. When you have this behavior there is nothing wrong with the printer, in fact you have an ...
Small parts print very bad and undefined. Lower temperature. Print slower. Print more objects at the same time to give more time to cool.
Large amount of ripples around corners. This is always present in prints, but when it is disturbingly large the issue is normally that something is ...
When the printed object is very brittle and there are holes in the object. This means that per traveled distance not enough material is extruded. This underextrusion is caused by the extruder wheel slipping over the extruder wheel. Main causes of this are:
Extruder arm is not properly ...
When objects seem to have bad dimensions or if the printhead or table shows jumps during printing. Which shows like this:
Mechanical issues
Belt is defect
Pulley not properly fixed on motor shaft
In some cases there can be some piece of filament between the belt and the pulley, causing ...
