;

Troubleshooting - Issues After Printing, Print Quality

Set Descending Direction

4 Items

per page
  1. Z-Axis Moves Down Slowly When Idle For Pro The FELIX pro has a ballscrew with very low friction to ensure accurate z-axis movement. This in some cases especially with a heavy object can cause the z-axis to move down by itself at a low speed. When you have this behavior there is nothing wrong with the printer, in fact you have an ...
  2. Bad Final Part Print Quality Small parts print very bad and undefined. Lower temperature. Print slower. Print more objects at the same time to give more time to cool. Large amount of ripples around corners. This is always present in prints, but when it is disturbingly large the issue is normally that something is ...
  3. Holes In Printed Object Or Very Brittle Parts When the printed object is very brittle and there are holes in the object. This means that per traveled distance not enough material is extruded. This underextrusion is caused by the extruder wheel slipping over the extruder wheel. Main causes of this are:   Extruder arm is not properly ...
  4. Shifted Prints, Jumps During Printing When objects seem to have bad dimensions or if the printhead or table shows jumps during printing. Which shows like this: Mechanical issues Belt or the pulley is not properly fixed on motor axis. Also in some cases there can be some piece of filament between the belt and the pulley, causing ...
Set Descending Direction

4 Items

per page